Acroprint Relay Instructions User Manual download pdf

Acroprint Relay Kit Instruction.

The Signal and Access Relay Box is designed for use with Acroprint's badge reading terminals. It has two independent types

of switching circuits, a switched AC power line circuit and a mechanical relay circuit. Either circuit may be used to control AC

powered bells, alarms, horns, or door access electric strikes. DC and all low voltage powered devices MUST use the mechanical

relay contacts (an external power source is required).

For direct AC power line switched circuits use CON1:

- Direct switching means that the input voltage on CON5 is directly switched to CON1

- Connect the device to the CON1 terminal strip using AC OUT, NEUT and GND

connection points. Wires should be stripped ¼ inch.

- If you are using the badge terminal's Bell signal, slide the SW2 switch to side marked

BELL.

- If you are using the badge terminal's Access signal, slide the SW2 switch to side marked

ACCESS.

For mechanical dry contact relay switching use CON2:

- Connect the device to the CON2 terminal strip using NO and COM connection points.

Wires should be stripped ¼ inch.

- If you are using the badge terminal's Bell signal, slide the SW1 switch to side marked

BELL.

- If you are using the badge terminal's Access signal, slide the SW1 switch to side marked

ACCESS.

Notes:

1. Existing External Card Readers can be connected to CON4

2. SEE REVERSE SIDE FOR GRAPHICAL DEPICTION OF ELECTRICAL CONNECTIONS

Specifications:

Input Voltage: 120VAC/240VAC 50/60 Hz

Input Current: 2 Amps Maximum

AC Output: 120VAC/240VAC 50/60 Hz

Relay Circuit: 5A at 250AC or 30VDC

Operating Temp. 0 to 50 degrees C

Humidity: 0 to 90% RH Non Condensing

Dimensions: 8 ¾" x 6" x 2"

WARNING:

Your installation must meet all National and Local electric codes. A licensed

electrician should perform installation.

p.t.o

06-0211-000

Rev.C

1 2

Specifications: 1
EXTERNAL 2

Summary of Contents

Page 1 - Specifications:

RAcroprint Relay Kit Instruction.The Signal and Access Relay Box is designed for use with Acroprint's badge reading terminals. It has two indep

Page 2 - EXTERNAL

DOORCON1CON 2CON 3CON 4CON 5RELAYAC OUTSW1SW2NCCOMNOK1LINENEUGNDBELLACCESSACCESSBELL EXTERNALSLOTREADER3/8"3/4"F1 2 AMP 250VDELAYF2 5 AMP

Comments to this Manuals

No comments

Acroprint Relay Instructions User Manual

Browse online or download User Manual for Routers Acroprint Relay Instructions. Acroprint Relay Instructions User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Routers Acroprint Relay Instructions